The rectangular grid tool is a real pain in the donkey' rear end. I just click on the field describing the layer and rename it accordingly. I also learned that I can rename any particular layer in the layer' panel. If I didn't want that line then I'd just drag it to the delete bin at the bottom of the Layers Panel. So, if I wanted to keep the line, I was able to make it much lighter. When I clicked that dot, I was able to adjust the stoke of a line from 3pt to 1pt, or. I also figured out that by clicking on the unwanted line, a dot to the right of that line, appeared in the Layers panel. Later on, after I copied and pasted what I did in my upper left section into the other seven sections of my page, I was even able to either eliminate the unwanted guide lines by using the Layers panel. It was kind-of hard to accomplish the 1/4", inner section perimeter white space boarder, but I used the Line tool, with a stroke of 3pt, to help me achieve this. This allowed me to print out my page without worrying about having anything truncated at the top, left, right, or bottom of my page. In other words, I didn't print any type or put a picture or graphic in any of those white space areas. I left 1/4 inch (0.25") white space around the inner perimeter of each of my eight sections. So, here's how I got around that problem: Now, I started to work on designing what I wanted in the upper left most section.īut I later realized my printer was not going to print Edge to Edge, which created another problem. This gave me the eight sections that I wanted. Then I used the line tool with a stroke of 3pt to draw lines at the various points on the grid. Then I selected View > Show Grid which by the way was very helpful. That helped me get the eight sections I wanted. I calculated by 8.5" x 11" page into eight sections as follows: The width is 8.5", so dividing it in half equals 4.25" x 2. I got so upset with trying to use it, that I accomplished what I wanted to do in a different way. There is no need for the Rectangular Grid. xaml export that exports a bunch of Canvas and Paths but not sure if this is the right starting point.Thanks for taking time to address my concerns.Īs I (mis)understand it, there is no need for the Recatngular Grid. Obviously there is a tool hiding somewhere but I have no idea where/what it is.Ĭan someone point me in the right direction on how to go about defining a new Icon Pack? I assume that the Icons are drawn as SVG files and the paths are used as the Icons, is this correct? If so is there a particular convention that needs to be used when drawing the Icons? I have both Inkscape and Corel Draw and noticed that Inkscape has a. I downloaded the library hoping to find an example of how to accomplish this and found that there are several "Auto Generated" files for the different Icon Packs. I have found all sorts of information on how to use them but nothing on how to define custom Icons. I have searched high and low for some information on how to define Icons using the library. This application requires extensive use of Icons and I need to create some additional Icons. I am working on a project that utilizes the Mahapps Metro Library, everything is going smoothly except for one issue.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |